Skip to content

CH4x4 Small Push Switch for Toyota – Front Air Locker Symbol

$23.98

Identify a suitable front-locker control circuit with the Front Air Locker legend. This 32.5 × 22 mm Small Push switch has a matte black laser-etched face and dual LEDs. Verify the locker system’s input requirements; 12V 3A ON/OFF switching requires a fused relay.

The Front Air Locker push switch gives a suitable locker-control installation a clearly identified front-axle button. Its marked face helps distinguish this control from a rear-locker or compressor button when several accessories share the panel.

Front Air Locker interface checks

Verify the locker manufacturer’s electrical control requirements before connecting the switch. The published arrangement is electronic Single Pole Single Throw ON/OFF, rated at 3A at 12V, with short circuit protection.

The accessory MUST be wired through a fused relay in ALL cases. The label does not guarantee a direct match with a particular locker harness, and the switch does not include the pneumatic or mechanical locking equipment.

Indicator behavior

The upper LED is ON when the button is pressed IN. It indicates switch position rather than confirmed axle-locker engagement. The lower LED may be wired to a separate dash-light circuit, following the supplied diagram.

Panel fit and construction

The 32.5 × 22 mm face, approximately 1.28 × 0.87 inches, combines a matte black hard surface with a laser-etched Front Air Locker legend. Heavy-duty ABS construction supports an OEM-style factory look.

Compatible with Toyota mounting applications

Check the year and available switch opening. Tacoma fitment is center console only. For entries marked ON, confirm the exact year and mounting space. This list concerns physical mounting, not locker-system compatibility.

  • Toyota Tacoma 2012–2023 (Center Console ONLY)
  • Toyota Tundra 2008–2021
  • Toyota 4Runner 2010–2024
  • Toyota Land Cruiser Prado 150 Series 2010–2014
  • Toyota Land Cruiser 200 Series 2008–2013
  • Toyota Sequoia 2008–ON
  • Toyota Corolla 2006–2013
  • Toyota Highlander 2008–ON
  • Toyota RAV4 2008–2012
  • Toyota Yaris 2008
  • Toyota Camry 2011–2014

Package contents

The package includes one Small Push ON/OFF switch and one connector with cable, with a wiring diagram supplied.

A locker, compressor, system interface and fused relay are not listed as included. Compare other Small Push controls for your layout. The relevant Toyota owner’s manual provides information about original vehicle controls.

Weight 2 oz
Dimensions 5 × 5 × 3 in
Switch Action

On-Off

Vehicle

Toyota

Switch LED Color

Amber, Blue, Green, Red, White

Switch Type

Square Push

Function

On-Off

Controls

Front Locker

Voltage

12V 3A (Push Toyota)

Compatibility

OEM Toyota

Built For Real-World Use

Every CH4x4 Small Push Switch for Toyota – Front Air Locker Symbol is laser-etched directly into the switch face — not printed or stickered — so the design holds up to years of sun, wash bays, and trail use instead of fading or peeling off. Sized to the OEM-style dash opening used across Toyota applications.

Frequently Asked Questions

Is this switch On-Off or Momentary?

This is a On-Off switch — it latches in place and stays on until you flip it back off, ideal for lights and accessories you run continuously.

What vehicles is this switch compatible with?

This switch is built for Toyota applications.

Is the design laser-etched or a sticker?

Laser-etched, directly into the switch face — not a sticker or ink print, so the design won't fade, peel, or wear off over time.

What do I need to install this switch?

Just basic hand tools and simple 12V wiring — this switch drops into a standard dash opening and wires the same as any single-pole 12V accessory switch.

You Might Also Need