CH4x4 Small Push Switch for Toyota – Audio Power Symbol 2

$23.98

Audio Power Symbol 2 is the alternative audio graphic in the CH4X4 Small Push lineup. Select it to coordinate the labels in your panel while retaining a matte black, factory-look finish.

The kit supplies an ON/OFF switch, connector with cable and wiring diagram. Upper and lower LEDs; rated 3A at 12V. The accessory requires a fused relay.

Switch LED Color

Clear

Description
Additional information

Audio Power Symbol 2 lets you choose a different visual identity for an audio accessory control. This CH4X4 Small Push listing is dedicated to the second audio graphic, with the same clearly stated ON/OFF operation and electrical limits shown below.

Is Audio Power Symbol 2 the design you need?

Compare the artwork before deciding where the switch belongs in your layout. The legend is engraved directly into the hard black face using laser etching. Its heavy-duty ABS housing has a matte black finish for an OEM-style appearance in compatible Toyota interiors.

If you prefer the other artwork, the standard Audio Power design has its own listing. Select the graphic that best identifies the circuit rather than assuming that a different symbol changes the switch capacity.

What arrives in the package?

One ON/OFF Small Push switch and one connector with cable are included. The supplied wiring diagram covers the switch connections. The face surface is 32.5 × 22 mm (approximately 1.28 × 0.87 in), so verify the intended opening before installation.

How do the two LEDs operate?

The upper LED is ON when the switch is pressed IN. The lower LED can connect to a separate dash light circuit. These two lighting roles allow the label and pressed-in state to be identified according to your wiring arrangement.

How should the accessory be connected?

Audio Power Symbol 2 is an electronic Single Pole Single Throw switch rated at 3A, 12V, with short circuit protection. In all cases, the accessory MUST be wired through a fused relay. Use the included diagram alongside your audio equipment instructions. See the relay and harness product for related hardware.

Which Toyota locations are listed?

Toyota Tacoma 2012–2023 (Center Console ONLY)
Toyota Tundra 2008–2021
Toyota 4Runner 2010–2024
Toyota Land Cruiser Prado 150 Series 2010–2014
Toyota Land Cruiser 200 Series 2008–2013
Toyota Sequoia 2008–2014
Toyota Corolla 2006–2013
Toyota Camry 2011–2014

The Tacoma entry is center console only. Confirm the year, model and switch position together when checking fitment.

Weight	2 oz
Dimensions	5 × 5 × 2 in
Switch Action	On-Off
Vehicle	Toyota
Switch LED Color	Amber, Blue, Green, Red, White
Switch Type	Square Push
Function	On-Off
Voltage	12V 3A (Push Toyota)
Compatibility	OEM Toyota

Built For Real-World Use

Every CH4x4 Small Push Switch for Toyota – Audio Power Symbol 2 is laser-etched directly into the switch face — not printed or stickered — so the design holds up to years of sun, wash bays, and trail use instead of fading or peeling off. Sized to the OEM-style dash opening used across Toyota applications.

Frequently Asked Questions

Is this switch On-Off or Momentary?

This is a On-Off switch — it latches in place and stays on until you flip it back off, ideal for lights and accessories you run continuously.

What vehicles is this switch compatible with?

This switch is built for Toyota applications.

Is the design laser-etched or a sticker?

Laser-etched, directly into the switch face — not a sticker or ink print, so the design won't fade, peel, or wear off over time.

What do I need to install this switch?

Just basic hand tools and simple 12V wiring — this switch drops into a standard dash opening and wires the same as any single-pole 12V accessory switch.