Keep a manual camera-power control easy to find with this push switch for Toyota backup camera. The camera outline and BACKUP CAMERA lettering identify its purpose without crowding the factory-style panel.
Backup Camera Symbol: design and use
Use the maintained button for a compatible camera power circuit designed around a fused relay. It does not carry video signals, select a display input or automatically interpret the vehicle’s reverse signal. Confirm the camera and monitor requirements before choosing the control arrangement.
push switch for Toyota backup camera: Large Push specifications
- 39 × 21 mm face (approximately 1.54 × 0.83 inches). This is the face size, not the mounting cutout.
- Single Pole Single Throw (SPST), maintained ON/OFF operation: press IN for ON and press again for OFF.
- Electronic switch rated at 3 Amp, 12V, with short circuit protection.
- Heavy-duty ABS body with a hard matte black face and an OEM-style appearance.
- Backup Camera Symbol laser etched directly into the face.
- Two LEDs: an upper ON indicator and a lower panel light.
- Upper LED illuminates when the switch is pressed IN.
- Lower LED can be wired to a separate dashboard-light circuit.
Wiring and installation — fused relay required
A fused relay is required in ALL installations. Accessory power must not run directly through this 3A, 12V switch.
Install the push switch for Toyota backup camera using the supplied wiring diagram and the connected equipment’s instructions. Choose relay capacity, cable size and fuse protection for the actual load. The included connector and cable serve the switch side, not the complete accessory power circuit.
The CH4X4 marine-grade waterproof 12V 40A relay with 4-pin harness is available separately.
What is included
- 1 CH4X4 push switch for Toyota backup camera — Backup Camera Symbol.
- 1 connector with cable.
- Wiring diagram.
Product SKU: CH4X4-TOY-REACAM1. Relay and controlled equipment sold separately.
Compatible Toyota mounting applications
Check the model year, trim, market and actual dashboard opening before ordering. Observe the position restrictions below. Mounting fitment does not establish electrical compatibility with the controlled equipment. This is a CH4X4 aftermarket product for compatible Toyota applications.
- Toyota Tacoma 2005-2011
- Toyota Tacoma 2012-2015 (Left Side ONLY)
- Toyota Tacoma 2016 – 2020 (Left Side ONLY)
- Toyota FJ Cruiser 2007-2014
- Toyota Fortuner 2005-2014
- Toyota Hilux 2005-2014
- Toyota Highlander 2001-2007
- Toyota Tundra 2005-2006 (Center Console if equipped)
- Toyota 4Runner 2003-2009
- Toyota Prado 120 Series 2003-2009
- Toyota Land Cruiser 100 Series 1998-2007
- Toyota Land Cruiser 75, 76, 78 & 79 series
